The The This post was last edited by fyubo at 2020-7-813:30 First come cost, as long as 10 yuan! ! ! : process: First print a hole map, which just has a rough outline, cut the acrylic according to this. Do the upper and lower base plates. Acrylic bought 20302mm, use a hook knife, pull it twice, and cut it once it is broken. Then I put on the screws and copper pillars. I plan to build a usb fan later, so I made it a little higher. The bottom is M26, and the top one is M215 and M210. The remaining material of the acrylic board is sufficient, just enough to make the lower side board, and the hole can be drilled and polished at a certain position. A little bit ugly Finally, fix the lower side panel with hot-melt adhesive and finish it!

-------------------------------------------- ---------
Netizen Reply: The The Quote: inkedus published in 2020-7-813:31 It's a pity not to be a designer, do you have a shop yourself?
Netizen Reply: The The Quote: inkedus published in 2020-7-813:31 It's a pity not to be a designer, do you have a shop yourself?
Netizen Reply: The The Citation: fyubo published in 2020-7-813:41 No, I am not a professional, I am bored to do it. Acrylic drawings are expensive to process, so I have to make one manually...
Netizen Reply: The The Quote: inkedus published in 2020-7-813:43 Know it

Label: none